FIT Tech
forum
Supercharged
products
Ecotec
products
VIP
Products
Packaged deals
how to buy
testimonials
FAQ
¼ mile
Featured Cars
videos
dyno
power plan
contact us
FIT Workshop
FIT Calais
Project
XU-6
V6 S/C
Conversions
Products
 
Type S - Cold Air Intake Kit

FIT Promotional Price $315 (inc. GST)
was $375 RRP (inc. GST) Save $60

The complete Type S - Cold Air Intake Kit kit comes with:

  • 1 x 4" MAF Intake Pipe
  • 1 x New Modified Lower Air Box
  • 1 x MAF Relocation Connector
  • 1 x 3" Rubber Inlet Duct
  • 1 x 2.5" Rubber Inlet Duct
  • 2 x 90-110mm Clamps
  • 2 x 80-100mm Clamps
  • 1 x Electrical Insulation Tape
  • Installation instructions

Shipping available to all regions in Australia

How To Buy  - Print Me

FIT Type-S CAI - Innovatively Different
Traditional CAI kits, whether factory or aftermarket, are mostly designed around the same theme of sitting the intake snorkel on top of the radiator and hope that some cold air gets pushed in. Our design is innovatively different.

We have fabricated new moldings from scratch that allow for cold air to be picked up from strategic locations to allow the coldest air possible to enter the Air box. The result is a significant increase in performance, throttle response, acceleration and power consistency. One of the other noticeable advantages is the improvement in Induction Whine and Supercharger noise. You can actually hear your M90 Supercharger working now!!

Power Improvements of 4-9kW and 10-20Nm More Torque coupled with Greatly Improved Throttle Response and Induction Sound. This CAI kit is the Best Available for V6 Ecotec and Supercharged V6's. Our Street series design does not require any cutting, it is a ready-to-go design that that only takes 15mins to install and significant gains are experienced on your first drive !

      
Why is FIT's Type-S Intake better than traditional designs?
A road car spends most of it's time in traffic, sitting still. When they do get going it's only usually up to 60 - 110 kilometers per hour. Then they have to come to a stop again. ¼mile testing is done from a dead standstill, and usually involves lengthy waits in the queue before having your run. That CAI on top of the radiator is soaking in heat all the time.

All this stop start type driving as well as heat soak from the radiator, fans and engine to the CAI pick-up on most Commodores makes this traditional type of CAI less effective the longer you have the engine running for. Next time you pull up after about 30 mins driving, pop the bonnet and feel the CAI inlet and tube and try and tell us it's not hot.

While you’re at it, put your hand under the front bumper bar, and feel how much cooler it is there. This is where we are picking up the air with our Street series CAI kit. We have designed it well to avoid any radiant heat from penetrating the piping and spoiling the cold air that is being sourced from outside.

Think about it logically and you will see our product by design is technically superior to traditional CAI's along with a Comprehensive Component makes it great value.

 
Type S - Cold Air Intake Kit Videos
Listen to the awesome sound of Induction Whine from the Supercharger from our FIT Calais. We achieved this by upgrading to our new FIT Type-S CAI system. Now you can actually hear your M90 Supercharger working!!

Also listen to the beefy sounding Exhaust from upgrading to FIT’s new fully Mandrel Bent 3” Single Exhaust system. Typically it’s very difficult to get a Supercharged V6 to sound good, but the single 3” system sounds incredible!

How To Buy  - Print Me

Back to Products

FIT Registration
Already registered?

 

home about products FAQ how to buy testimonials power plan dyno videos hall of fame links contact

For further information, contact:

v6supercharged@bigpond.com

Forced Induction Technologies
PO Box 842 Victoria Park WA 6979
Tel: 0413 900 900

Copyright 2002-2008
Forced Induction Technologies Australia - Specialists with V6 Performance Parts

The owners of this website take no responsibility for the accuracy or otherwise of any information supplied on this website. All pictures on this website are the property of the publications in which they originally appeared, unless otherwise stated. This website is best viewed in true colour and at full brightness, using Internet Explorer 6 or higher, with a resolution of 800x600. Use of any other browser may result in strange or funny experiences.

For web design queries, contact Supercharger Kit